To start the rinse of your milk pot to remove all traces of milk in the system and ensure the
performance of your machine.
Settings
Enables you to set your water hardness at a value between 0 and 4 by pressing the keys
See Water hardness below.
Enables you to activate or deactivate automatic rinsing each time the machine is switched on. Press
the start/stop key
Enables you to choose the period of non-use after which your appliance will stop automatically, from
15 to 120 minutes, by pressing the keys
Enables you to adjust the temperature of your coffee by pressing the keys
Switching off
You may stop your appliance at any time. While the appliance is stopped, it produces a double beep and OFF is
displayed on-screen.
The appliance has received your request and will stop as soon as possible.
!
If one of the problems listed in the table persists, contact the KRUPS customer service department.
The appliance does not turn on after
Si l'un des problèmes énoncés dans le tableau persiste, appelez le service consommateurs KRUPS.
pressing the Start/Stop key.
The logo
is displayed
A power outage occurred during a cycle.
The appliance is operating, but no liquid
comes out.
32
to activate and the key
PROBLEMS AND CORRECTIVE MEASURES
to deactivate.
.
Turn off and unplug the machine, remove the filter cartridge; wait
20 seconds and restart the machine. Check that the plug of the
electrical cord is properly pushed into the outlet
Unplug the appliance for 20 seconds, remove the Claris Aqua
Filter System cartridge if applicable, then put it back into service.
The appliance automatically resets itself when its switches on
again and is ready for a new cycle. If the power outage takes
place during a cleaning or descaling cycle, the machine will
continue the cycle at the step under way during the incident.
Check that the water reservoir is properly in place and that the
cord is not jammed between the body of the appliance and the
water reservoir.
.
, 3 levels available.