Closing The Doors And Leveling; Door Alignment - LG LTCS20220 Série Mode D'emploi

Tighten the bolts. Force-fit Top Hinge Cover over Top
Hinge.
Replace cover on the top left side of the refrigerator
to the right top to cover the holes. Cover is also
force-fitted.
Cover (on top of
refrigerator)
After changing doors, make sure that the corners
of the Door Gaskets are not folded over. To ensure a
good seal, apply a small amount of silicon grease on
the corners of gaskets.
REFRIGERATOR INSTALLATION
REFRIGERATOR INSTALLATION

CLOSING THE DOORS AND LEVELING

To avoid vibration, the unit must be leveled. If necessary,
adjust the leveling legs to compensate for unevenness of
the floor. The front should be slightly higher than the rear to
aid in door closing.
The refrigerator has two front leveling legs, one on the right
and one on the left. If your refrigerator seems unstable or if
you would like the doors to close more easily, simply adjust
the tilt of the refrigerator by following the instructions below:
1.
2.
NOTE: Having someone push against the top of the refrig-
erator takes some weight off the leveling legs. This will make
it easier to adjust the level.
3. Open both doors again and check to make sure that
Corners
12
Plug the refrigerator into a 3 prong grounded outlet.
Move the refrigerator into its final position.
Use an 11/16" (18 mm) wrench or an adjustable wrench
to adjust the leveling legs, turn the leveling legs to the
left to raise that side of the refrigerator or to the right to
lower it. It may take several turns of the leveling leg to
adjust the tilt of the refrigerator.
they close easily. If they don't, tilt the refrigerator slightly
more to the rear by turning both leveling legs to the left.
It may take several more turns, and you should extend
both legs the amount.

Door Alignment

If the space between your doors is uneven, follow the
instructions below to align the doors:
1. Gently pry off the Top Hinge Cover with a flat head
screwdriver and remove.
2. Loosen the Top Hinge Bolts using a 10 mm or 13/32
inch socket wrench or open-end wrench.
3. Have someone hold the freezer door so the space
between the two doors is even, and retighten the top
hinge bolts.
4. Replace the Top Hinge Cover.