Closing And Aligning The Doors - LG LFCS25663 Série Manuel De L'utilisateur

CLOSING AND ALIGNING THE DOORS

Closing the Doors
Your refrigerator has two front leveling screws, one on
the right and one on the left. If your refrigerator seems
unstable or if you would like the doors to close more
easily, simply adjust the inclination of the refrigerator by
following the instructions below:
1. Plug the refrigerator into a 3 prong grounded outlet.
Move the refrigerator into its final position.
2. Use a flat head screwdriver to adjust the leveling screws,
turning clockwise to raise the side of the refrigerator
and counter-clockwise to lower it. It may take several
turns to adjust it to the inclination you would like.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws.
This will make it easier to adjust the screws.
3. Open both doors again and check to make sure that
they close easily. If not, slightly tilt the refrigerator
further back by turning both leveling screws clockwise.
It may take several more turns. Make sure that you turn
both leveling screws the same amount.
4. Ensure that the refrigerator is even by using a level.
5. Replace the base grille.
NOTE: Your new refrigerator is uniquely designed with
two fresh food doors. Either door can be opened or
closed independently of one another. You may have
to exert slight pressure on doors to get them to close
completely.
REFRIGERATOR INSTALLATION
Door Alignment
The left refrigerator door has an adjustable nut, located
on the bottom hinge, to raise and lower, the door for
proper alignment.
If the space between your doors is uneven, follow the
instructions below to align the doors evenly:
Use the wrench (included with the Use & Care Guide) to
turn the nutin the door hinge to adjust the height. To the
right to raise or to the left to lower the heignt.
The right refrigerator door does not have an adjustable
nut.
If the space between your doors is uneven, follow the
instructions below to align the right door:
1.
2. With the other hand, use pliers to insert the snap
3. Insert additional snap rings until the rignt door is
When moving your refrigerator
Note: Your refrigerator is extremely
heavy. When moving the refrigerator
for installing, cleaning or service be
sure to follow the next instructions.
1.
2.
3.
1
With one hand, lift up both the inner and outer door
sections of the right door to raise them at the
middle hinge. (Opening the door may make lifting
easier).
ring on the middle hinge of tjhe inner door section
as shown. Do not insert the ring on the hinge of the
outer door section.
aligned. (Two snap rings are provided with the unit).
Adjust leveling legs up.
Cover the floor with cardboard or hardboard to
avoid floor damage.
Always pull or push the refrigerator straight out
when moving it. Do not wiggle or "walk" the
refrigerator when trying to move it, as floor damage
could occur.