Using The Probe - General iBORESCOPE4 Manuel D'utilisation

As mentioned earlier, there
are two options not visible
on the Setting screen when
it launches. If you scroll
down, you will see them:
Reset to Default and
About. Touching the Reset
to Default button on the
Setting screen produces
the screen at right.
Touch OK to restore all factory defaults and reboot iSnakescope. Otherwise,
touch Cancel to return to the Setting screen.
Touching the About button
produces the Setting
screen shown below—
including the important
Version number and
release date of the app.

USING THE PROBE

If you are unfamiliar with video borescopes, be aware that professional users
like contractors and technicians typically insert a borescope probe into an
orifice (a hole in a wall or an engine's cylinder, for example) or into an
inaccessible or hazardous area (the back or an equipment rack or an engine
compartment, for example) to view components or environments that would
otherwise be invisible. Use the brightness adjustment thumbwheel (Fig. 1,
Callout 2) to match the intensity of camera lighting to the application
environment.
In practice, professionals usually insert flexible-obedient probes like the one
that comes with iBorescope4 head-on into an orifice or area as a first step.
They then pull the probe out and adjust its bend one or more times until the
camera in the tip is pointing directly at the target or area of interest. With the
probe inserted, you can twirl it until video appears right-side up, but in many
cases you cannot change the probe's angle of approach very much.
17