AEG S26KA78 Notice D'utilisation page 15

10. Remove the hinge. Put over the pin in
the direction of the arrow. Install the
hinge on the opposite side.
11. Tighten the hinge.
12. Put the top in position.
13. Push front the top.
14. Screw both screws on the rear side.
15. Remove and install the handle
opposite side.
16. Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The After Sales Service specialist will carry out the rever-
sibility of the doors at your cost.
3) If foreseen
3
3)
on the
Installation
1
2
15
2
1
3