Switching Off - Bosch Household Appliance Mode D'emploi

en
Warning!
Do not under any circumstances
whatsoever connect the appliance to
electronic energy-saving connection
devices (e.g. Ecoboy, Sava Plug, etc.)
or inverse rectifiers which convert DC
currents into 230 AC currents (e.g.
solar energy systems, maritime
electricity systems).
Turning on and
temperature
selection
Clean the inside of the appliance
thoroughly, before using the first time
(see cleaning).
Turning on
Turn temperature selector (figure E)
out of the position "O".
The refrigerating process begins.
Should the door of the freezer
compartment refuse to come open
shortly after having closed it, please wait
for two or three minutes for the suction
produced, when the door was first
opened, to release.
Temperature selection
Use the temperature selector (Figure E)
to adjust the temperature of both freezer
and refrigerating compartments.
Observe the high figures yield low
degrees of temperature.
When the temperature selector is placed
at setting "O" the refrigerating process is
turned off.
From setting "1" onwards it starts and
increases.
18
We suggest a medium temperature
setting (approximately "2-3")
To freeze foods, rotate the temperature
control to "3" (see also "Freezing").
Observe the following for
the storage of frozen
food:
If the temperature of the room where the
appliance has been placed drops below
+18ºC the freezer switch should be
connected. A red mark will indicate it is
on (figure E/22). On connecting the
switch, the inner light will remain on at
reduced power. This ensures that the
temperature required in the freezer
compartment for long-life storage of food
is maintained.
Switching-off and
setting out of use
Switching-off
Turn the temperature selector (Figure E)
to the setting "O".
The refrigerating process stops for the
whole appliance.
Setting out of use
If the appliance is set out of use for a
long period of time, unplug, allow to
defrost and clean. Leave the door of the
freezer compartment and appliance's
door open.