Witter F127B Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar
B 2 Side Arm
C 4 M10 x 35 x 1.5mm Bolts, Lock Washers, Flat Washers (30mm O.D.) and Witter Cage Nuts
D 4 M12 x 40 x 1.75mm Bolts, Lock Washers and Nuts
CB 2 M16 x 50mm Coupling Bolts, Nuts, Lock Washers
Z 1 ZEP35 Electrical plate (not shown)
FITTING
1 Remove bumper (2 tip screws each side, 1 nut behind wheel arch liner each side, remove reflectors from top of
bumper – pull out from inside end first – 1 screw behind reflector each side, 2 plastic screws on lower edge of bumper.
Pull bumper tips out sideways then pull bumper rearwards.
2 Remove bumper beam.
3 Pre-assemble the four Witter Cage Nuts and insert two into each Side Arm (B). Take care to insert into the correct
side of each Side Arm as shown below.
4 Insert Side Arms (B) into chassis and attach from the outside of the chassis using fasteners (C). Cut off large plastic
tab from centre of plastic rear panel. Loosely attach Cross Bar (A) to Side Arms (B) using fasteners (D).
5 Fully tighten all bolts.
6 Cut bumper as shown. Re-fit bumper.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
GRADE 10.9: M12 – 139Nm
W0001F127B-FIT$011103150000"Ä
W0001F127B-FIT$011103150000
TOWBAR
For Ford Focus C-Max 2003-
GVW – 2065kg
Max. Trailer – 1500kg
S-Value – 75kg
D-value – 8.52kN
F127B