Resetting The Camera - Lorex LNZ32P4 Série Manuel D'instructions

8

Resetting the Camera

The camera features a hard reset button that is used to reset all camera settings back to
their default values. This is useful in case you want to revert camera image settings back
to their default values.
To reset the camera to default settings:
1. Connect the camera as detailed in 3 Connecting the Camera. Make sure the camera is
powered on.
2. Use the Allen key included with the camera mounting kit to loosen the dome camera
cover screws (x3). Remove the dome camera cover.
3. Press and hold the reset button below the camera module for at least 10 seconds to
reset the camera to default settings.
NOTE
It may take few minutes for the camera image to reappear on the screen.
NOTE
This camera does not support micro SD card recording.
#LX400075; r.34407/34407; en-US
21