Auto Recipe; Control Lockout - GE JCKP30-27 Manuel Du Propriétaire

+
or
+
or
(depending on model)
Changing the Speed of the + or – Pads
As you use the + or – pads when setting a
time or temperature, you may notice the display
changes slowly. This special feature allows you
to change the speed. To set the speed you prefer,
follow the steps below.
Press the Bake and Broil Hi/Low
pads at the same time for 3 seconds,
until the display shows SF.
Press any + pad. The display will
show you a set speed between 1
and 5.

Auto Recipe

™ Conversion
When using convection bake, the Auto Recipe
Conversion feature will automatically convert
entered regular baking temperatures to
convection baking temperatures.
Once the feature is activated, the display
will show the actual converted (reduced)
temperature. For example, if you enter a regular
recipe temperature of 350°F (177°C) and press
the Start pad, the display will show CON and
the converted temperature of 325°F (163°C).
NOTE: This feature does not convert convection
bake cooking times, only regular baking
temperatures.

Control Lockout

Your control will allow you to lock out the press
pads so they cannot be activated when pressed.
To lock/unlock the controls:
Press the Hour and Min – pads or
the 9 and 0 pads (depending on
model) at the same time for 3
seconds until the display shows
LOC ON.
To unlock the control, press the
Hour and Min – pads or the 9 and 0
pads (depending on model) at the
same time for 3 seconds until the
display shows LOC OFF.
(on some models)
Press any + pad to increase the
speed up to the number 5.
Press any – pad to decrease the
speed down to the number 1.
Press Start to activate the setting and
leave the control set in this special
features mode.
(on some models)
™ To activate the feature:
Press the Bake and Broil Hi/Low pads
at the same time for 3 seconds, until
the display shows SF.
Press the Convection Bake pad. The
display will show CON OFF. Press the
Convection Bake pad again. The
display will show CON ON.
Press the Start pad.
To deactivate the feature, repeat steps
1–3 above but press the Start pad when
CON OFF is in the display.
When this feature is on and the press
pads are pressed, the control will beep
and the display will show LOC ON.
I
The control lockout mode affects all press
pads. No press pads will work when this
feature is activated.
I
This adjustment will be retained in memory
after a power failure.
www.GEAppliances.ca
19