Citizen CT-S281 Mode D'emploi page 36

*1: For Bluetooth communication, 64k (BT model) or 256K (BD model) is available.
*2: Set to be invalid when Blackmark paper/label paper is selected by MSW4-4 and label detection
is selected by MSW4-5.
*3: When paper length setting is assigned as a command, use the command when specifying
paper layout. If there is no specification, paper length is set to default value. This is valid only
when Blackmark paper/Label paper is selected with memory switch 4-4.
*4: Only valid when Blackmark paper/Label paper is selected with memory switch 4-4.
*5: No cutting operation occurs when cutter is disabled with memory switch 2-2.
When thermal paper roll is selected, cutting operation occurs after paper is fed by about
30mm.
When Blackmark paper/Label paper is selected, cutting operation occurs after paper feed to
the top of the next print position.
*6: Paper select setting at the time of shipment depends on the model.
Standard: OFF (Thermal paper roll) Label: ON (Blackmark paper/Label paper)
*7: Valid only when Blackmark paper/Label paper is selected with memory switch 4-4.
Factory setting of paper position detection is subject to the model.
Standard: OFF (Blackmark detection) Label: ON (Label detection)
*8: MSW4-6 functions only when blackmark paper/label paper is selected by MSW4-4.
*9: MSW4-7 functions only when Blackmark paper/label paper is selected by MSW4-4.
*10: Invalid when Blackmark paper/Label paper is selected with memory switch 4-4. (Only for full
cut)
*11: Only valid when Blackmark paper/Label paper is selected with memory switch 4-4, and Label
is selected with memory switch 4-5.
*12: MSW7-1 through MSW7-5 do not conform to BT model and BD model.
— 33 —