Citizen CT-S281 Mode D'emploi page 20

3.3.2 Reconnect Request (BD model only)
With BD model,"MSW13-6 Reconnect Request" feature is provided for iOS
device. This feature is set to be valid at the time of shipment.
If this feature is valid, the printer tries to connect to the host connected last in
the following cases.
When printer is powered on
Bluetooth connection with the host has been cut off, or the like
When the same printer is used consecutively, it is not necessary to retry
connection by returning the "Setting" window of iOS.
CAUTION!
● If you are using a host other than iOS device, if reconnect request is valid, it may take
a long time to get connection. Even if printing is requested from iOS device, when you
want to disconnect Bluetooth communication at the end of each print operation or you
initiate printing from two or more iOS devices, keep this feature set to be invalid.
To change the setting of this feature, the following simple method is provided.
Press the FEED button 3 times during self-printing
Reconnect Request = Valid
Press the FEED button 4 times during self-printing
Reconnect Request = Invalid
(Self-printing is implemented by turning the printer power on while pressing
and holding the FEED button.)
— 17 —