Câblage Avec Un Sna Rack; Measuring Range; Error Listing - AMIX AFF 2 Série Manuel Utilisateur

REAR PANEL
Câblage avec un SNA Rack :
to connect to SNA R A connector
3 ) RJ45 opto mos relay output connector corresponding to alarm level exceeding.
GPO1
GPO2
Internal OPTO MOS wiring
CMD 2
CMD 1
4 ) RJ45 connector to ethernet (LAN)
5 ) B type USB connector for firmware upgrade only.

MEASURING RANGE

With A weighted, Leq level range is from 60 dB(A) to 122 dB(A).
However, it is possible, as an option, to measure from 40 dB(A) to 102dB(A).
With C weighted,Leq level range is from 60 dB(A) to 122 dB(A), and peak level range is from
70 dB(C) to 132 dB(C).
However, it is possible, as an option, to measure from

ERROR LISTING

Error listing which can be displayed by control display (B).
E2 : CAP 20 sensor link defect.
E3 : Low internal battery voltage. Replace quickly.
AMIX - AFFseries-2
XLR F plug
(see SNA manual)
1
+
SENSOR
-
V+
OPTO MOS 2
OPTO MOS 1
8
1
2
3
V+
4
5
6
7
8
-
3
3
2
1 2
1
Leds GPO1 and GPO2 display GPO1 and GPO2
state, and allow to recover the equipment IP address.
(see page 32)
Note :
Each OPTO can be considered as a relay and
offers all the advantages (alternative signals, no
wiring). Current limit is fixed at 200mA.
50 dB(C) to 112 dB(C).
29
AFFseries-2 plug
-
+
shielded cable
Next
ENGLISH