Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TR145
Installation Procedure for the individual Vehicle Model
Manufacturer
SUBARU
IMPREZA WRX
Vehicle preparations
→
Outside of vehicle
Roof
Fig-1
Carrier installation locations
FRONT
Front
Rear nut of the vehicle
REAR
Front
Front nut of the vehicle
Vehicle model
Vehicle type
IMPREZA
FORESTER
Cover
Protection sheet
Protection sheet
Fig-2
Model year
4,5 door
2008 - 2011
2012 -
5 door
4,5 door
2009 -
2014 -
Cleaning the installation area on the
vehicle
Wipe dirt and oil off the roof and moldings
using diluted mild detergent, and then dry
the wiped area.
*Shaded area in the figure.
●Do not use organic solvents such as thinner or benzene to
clean dirt and oil.
Lifting the cover of the carrier
installation locations
Applying the protection sheets
Apply 2 protection sheets at 4 carrier
installation locations (8 sheets total)
aligning their respective center to the
rear nut on the vehicle at the FRONT
installation locations.
On the REAR installation locations, align
their respective center to the front nut on
the vehicle. (See Fig-1), and also place
one edge of the protection sheet along
the radius curve of the roof molding
(See Fig-2).
End of radius curve
Protection sheet
Roof molding
EN-２
Loading conditions
Maximum
Load Capacity
140
lbs
(
kg)
64
( Load + Base rack
+ Attachments )
Protection sheet
4182808TR1452
EN
Bike
3
-EN
-A
Publicité
Table des Matières
