Changing The Air Filter; Testing For Leaks - Maximum 058-9318-6 Mode D'emploi

20
model no. 058-9318-6 | contact us 1-888-670-6682
CHECKING THE PRESSURE RELIEF VALVE
1. Turn OFF the power supply to the pump.
2. Pull the relief valve ring to check whether it s operating properly and to clear
possible obstructions of the valve.

CHANGING THE AIR FILTER

After continuous use of the compressor, the air filter may get clogged. This will reduce
the air intake capability of the compressor. Therefore it is necessary to clean frequently
or replace the air filter on a regular basis to avoid any internal contamination of the
compressor pump.
1. Turn OFF the power supply to the pump.
2. Remove the old air filter (1) from the
compressor cylinder head (FIG M).
3. Replace with a new air filter.

TESTING FOR LEAKS

Check whether all connections are tight. To find leakage
in hose, transfer tube, or pipe connection, spray a small
amount of soapy water around the damaged area with a
spray bottle. If bubbles appear around the area, repair or
replace the faulty component. Do not overtighten any connections.
STORAGE
Before storing the compressor for a prolonged period, follow the below steps correctly.
• Disconnect the power cord and coil it up on the handle.
• Clean all dust and debris from the compressor using an air blow gun.
• Pull the relief valve ring to release all pressure from the tank.
• Drain all moisture from the air tank.
• Cover the compressor to protect it from moisture and dust.
CAUTION!
• Potential hazard that may result in moderate injury or
damage to equipment.
• Wear safety glasses when opening the drain valve, as
the air and moisture releases out from the tank can
propel debris that may cause eye injury.
WARNING!
• Potential hazard that could result in serious injury or
loss of life.
• Make sure the tank is drained every day to prevent
corrosion of tank.
200-2952-B_ALA1983012 MAXIMUM MANUAL_VR_120616.indd 20
1
FIG. M
1/24/2017 8:28:22 AM