Samsung SESG RB34T Série Manuel D'utilisation page 49

A
Untitled-6 49
B
A
A
F
C
E
D
B
14. On the top of the freezer door, switch
the position of the grommet (A) and the
grommet cover (B).
15. Fasten the middle hinge (A) to the
opposite side of where it was removed.
- Use a Phillips screwdriver and socket
wrench (10 mm) to fasten the screws.
16. Disassemble the bottom hinge and
reverse all the parts.
a. Use a Phillips screwdriver to remove
the screw (A) fastening the fixer (B)
to the bottom hinge (C).
b. Use a spanner (10 mm) to remove
the nut (D) and washer (E) fastening
the shaft (F).
c. Flip the bottom hinge (C), and then
reattach the shaft (F) with the washer
(E) and the nut (D).
d. Fasten the fixer (B) with the screw
(A).
CAUTION
• Be careful not to drop the shaft (F) or
hurt your fingers when removing or
assembling the shaft (F).
• Make sure the washer (E) is in the
correct place. If the shaft is fastened
without the washer (E), the freezer door
may fall and cause injury.
English 49
2020-08-07 PM 12:24:50