Installing The Battery - Korg MiniPitch Manuel D'utilisation

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
CAN ICES-3 B / NMB-3 B.
Parts of the MiniPitch
En
Display
LED meter
C C E E
G G
A A
Power String name
button indicator LED
Since the MiniPitch is small and lightweight, infants may
try to put it in their mouths. Keep the MiniPitch out of the
reach of infants.

Installing the battery

Make sure to turn the power off
before you replace the battery.
When the battery runs low, the
LED meter will no longer operate
smoothly. Replace the battery as
soon as possible to ensure accurate
tuning.
1. Slide out the battery tray, which
is combined with the display.
2. Insert the battery, making sure to
observe the correct polarity.
3. Return the battery tray to its
original position.
Attaching to the instrument and range of motion
The MiniPitch tunes by picking up
the vibrations of the instrument.
For the most accurate tuning, be
sure to attach the MiniPitch to the
head stock of your instrument.
In addition, the display can be
moved as shown below, so that it
is easier to read.
The MiniPitch may be damaged if you apply excessive
force within its range of motion, or attempt to move it be-
yond its intended range of motion.
Please carefully attach the MiniPitch to your instrument.
Leaving the MiniPitch attached for a long time may dam-
age or mark the instrument's surface.
Depending on various factors such as agerelated change
or the surface finish, there is a possibility that your instru-
ment may be damaged by attaching this product.
Clip
Battery tray
10‒15
mm
110°
1. Press the power button to turn on the power.
2. Play a single note with the string that you want to tune.
3. Roughly tune the string until the string name indicator
LED for the string you're playing lights up.
4. Tune the instrument until the center of the LED meter
lights up. The lower side of the LED meter will light up if
your instrument is flat, and the upper side will light up if
your instrument is sharp.
5. To turn off the power, press the power button.
If approximately three minutes pass without the MiniPitch
detecting any sound, the power will turn off automatically
(Auto power-off).
The meter may respond to vibrations it picks up from the
environment; however, this will not affect tuning of the
instrument.
Autoguide mode
In Autoguide mode, you can move on to tuning the following
string once a string is in tune, starting from the 4th string (G).
This mode helps reduce tuning time and allows ukulele begin-
ners to tune with confidence.
1. Press the power button to turn on the MiniPitch.
2. Hold down the power button to enter the Autoguide mode,
and a string name indicator LED (G) blinks.
3. Play the string indicated by the blinking string name indica-
tor LED and tune it.
4. When the center of the LED meter lights up to indicate that
the string is tuned, the next string name indicator LED (C)
blinks.
5. Repeat these steps until all four strings are tuned.
6. When all strings have been tuned, Autoguide mode is exited.
TIP To cancel Autoguide mode, breifly press the power button.
Autoguide mode does not support Low-G tuning.
Scale 12-note equal temperament (A4=440Hz, fixed)
compatible with standard G, C, E and A tuning,
Detection
and Low-G tuning (except in Autoguide mode)
range
(sine wave) G3 (196.00Hz)–A6 (1760.00Hz)
+/-1 cent
Precision
Power supply coin-type lithium battery (CR2032) x 1
approximately 100 hours (continuous A4 input)
Battery life
Dimensions
43 × 29 × 24 mm / 1.69 × 1.14 × 0.94 inches
(W x D x H)
13 g / 0.46 oz. (including battery)
Weight
Owner's manual, coin-type lithium battery
Included
items
(CR2032) x 1
* Specifications and appearance are subject to change without
notice for improvement.
2
Tuning
C E
G
A
Specifications