Playing songs on iPod
For details about the supported iPod, refer to
iPod compatibility on page 62.
Basic Operations
% Fast forwarding or reversing
Push and hold MULTI-CONTROL left or right.
% Selecting a track (chapter)
Push MULTI-CONTROL left or right.
Notes
! When using an iPod, iPod Dock Connector to
USB Cable (CD-IU50) is required.
! Read the precautions for iPod in the following
section. Refer to page 62.
! If an error message is displayed, refer to Error
messages on page 57.
! When the ignition switch is set to ACC or ON,
the iPod's battery is charged while the iPod is
connected to this unit.
! While the iPod is connected to this unit, the
iPod cannot be turned on or off.
! Before connecting the dock connector of this
unit to the iPod, disconnect the headphones
from the iPod.
! The iPod is turned off about two minutes after
the ignition switch is set to OFF.
Browsing for a song
Operations to control an iPod with this unit is
designed to be as close to the iPod as possible
to make operation and song search easy.
! Depending on the number of files in the
iPod, there may be a delay when displaying
a list.
! If the characters recorded on the iPod are
not compatible with this unit, those charac-
ters are not displayed.
Searching songs by category
1
Press
/LIST to switch to the browsing
mode.
2
Use MULTI-CONTROL to select a cate-
gory.
Turn to change the category. Press to select.
PLAYLISTS (playlists)—ARTISTS (artists)—
ALBUMS (albums)—SONGS (songs)—
PODCASTS (podcasts)—GENRES (genres)—
COMPOSERS (composers)—AUDIOBOOKS
(audiobooks)
List for the selected category is displayed.
# You can start playback throughout the se-
lected category by pressing and holding
MULTI-CONTROL. You can also perform this op-
eration by pushing and holding
MULTI-CONTROL right.
# You can also change the category by pushing
MULTI-CONTROL up or down.
# You can also select the category by pushing
MULTI-CONTROL right.
# To return to the previous category, push
MULTI-CONTROL left.
# To return to the top tier of categories, push
and hold MULTI-CONTROL left.
# To return to the ordinary display, press
BAND/ESC.
# If you do not operate the list within about 30
seconds, the display automatically returns to the
ordinary display.
3
Repeat step 2 to find a song you want
to listen to.
# When you select PODCASTS, an episode list
is displayed.
Searching by alphabet in the list
1
Use MULTI-CONTROL to select a cate-
gory.
Turn to change the category. Press to select.
2
When a list for the selected category is
displayed, press
/LIST to switch to alpha-
bet search mode.
ABC SEARCH is displayed.
3
Turn MULTI-CONTROL to select a letter
of the alphabet.
Section
07
23
En