Moving Care; Problem Solver; Freezer Operation - Whirlpool WSZ57L18D Guide D'utilisation

Moving Care

When you are moving your freezer to a new home, follow these steps to
prepare it for the move.
1. Remove all frozen food.
2. Unplug the freezer.
3. Take out all removable parts, wrap them well, and tape them
together so they don't shift and rattle during the move.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer to the
warranty page in this manual and scan the code there with your mobile device, or visit www.whirlpool.com/product_help for recommendations
that may help you avoid a service call. In Canada, visit http://www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.

Freezer Operation

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
PROBLEM
Freezer Will Not Operate
Lights Do Not Work
Water in Defrost Drain Pan
Motor Seems to Run Too
Much

PROBLEM SOLVER

RECOMMENDED SOLUTIONS
Check that the freezer is not running an automatic defrost cycle (on some models).
Check that it is plugged into a grounded 3 prong outlet.
Check that the temperature control is turned on.
Replace the fuse or reset the circuit breaker.
NOTE: If problems continue, contact an electrician.
Check that it is plugged into a grounded 3 prong outlet.
Check that the light bulb is tight in the socket and is not burned out.
It is normal for water to drip into the defrost drain pan when freezer is defrosting.
When humidity is high, it is normal for water in the defrost pan to take longer to evaporate.
Check that door closes properly.
Defrost and clean the freezer to remove excessive frost.
Adding a large amount of food warms the freezer causing the unit to run longer to cool back down. If this is the
situation, wait approximately 6 to 8 hours to allow the freezer to reach the correct temperature.
Get all items out at one time, keep food organized and close door as soon as possible.
Check that the door gasket is sealed all the way around. If not, contact a qualified person or technician.
Check that space around freezer meets air circulation requirements. See "Location Requirements."
NOTE: If none of the above, your new freezer will run longer than your old one due to its high-efficiency motor.
4. Clean the freezer thoroughly.
5. Tape the freezer shut and tape the electrical cord to the cabinet.
When you get to your new home, refer to the "Installing Your Freezer"
and "Operating Your Freezer" sections for information on installation
and setting the controls.
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 – 6750 Century Ave.
Mississauga ON L5N 0B7
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
10
WARNING
Explosion Hazard