Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.
•
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
lamp explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
•
Mechanical wear and LEDs are not covered by warranty.
•
A qualified technician should install and service this device.
•
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
•
This device is designed for professional use on stage, in discos, theatres, etc. The VDPL1803MHRGB should
only be used indoors with an alternating current of 230 VAC/50 Hz.
•
Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
•
Use the original packaging if the device is to be transported.
•
Keep this manual for future reference.
4.
Features
•
small and light LED moving head, only 3.9 kg
•
runs extremely fast, with very bright output
•
suitable for clubs, stage, decoration, etc.
•
master/slave and sound control modes
•
DMX controlled by 5, 7, 9, or 12 channels
•
pan (504°/630°) and tilt (240°), self-correcting
•
very smooth dimming, narrow punchy beam
•
blue LCD display for easy configuration, auto switch off after 5 sec.
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
display
2
control buttons
3
power input
4
power output
6.
Installation
Choose a suitable mounting spot. Mount the fixture in the desired angle using the included bracket. Connect the
power cord to the mains. Disconnect after use.
Mounting the Device
•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
•
The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in injuries.
•
For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of the
(folded) bracket.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Make sure there is no flammable material within a 0.2 m radius of the device.
•
Have a qualified electrician carry out the electric connection.
V. 01 – 26/10/2012
VDPL1803MHRGB
5
DMX input
6
DMX output
7
safety cable attachment point
4
©Velleman nv
Publicité
Table des Matières
