Minea WP55G Mode D'emploi page 14

•
At the end of the cycle the dishwasher will stop, the light will stop flash, the
dishwasher will beep. The light will be crush out when the machine does not run or
operate over 10 minutes. The power light remains illuminated, until the power (on/off)
button is switched off.
•
The dishwasher is designed to stop if the door is opened accidentally during
operation.
•
You may select another program during operation by pressing the Pause/ Resume
key 3s, then pressing the program key to the desired program, and pressing the
Pause/ Resume key to start.
•
After washing, dishes should be allowed to cool down for about 15 minutes so they
are not too hot to handle. Dishes will cool quicker if the door is opened slightly.
•
After unloading the dishwasher, remove the filter, clean off any bits of food, and put
the filter back in its position.
Note : Please do not open the door when dishwasher is running. The door could be allowed
to open after pressing the pause button.
At the beginning of each cycle, the dishwasher always starts in the "drain" mode. This is
because the drain pump always retains a small amount of water (in the sump) from the
previous cycle. This is necessary to keep the pump primed. Therefore, do not be alarmed if
you see a small amount of water being pumped-out from the drain hose prior to the start of
the regular wash cycle (this is normal).
7. Programs
•
Intensive wash
Water Maximum High Temperature:
Programme Duration + Heating Time:
Water Consumption:
•
Normal wash
Water Maximum High Temperature:
Programme Duration + Heating Time:
Water Consumption:
•
Rapid wash
Water Maximum High Temperature:
Programme Duration + Heating Time:
Water Consumption:
•
Pre rinse
Water Maximum High Temperature:
Program Duration:
Water Consumption:
The washing time may vary according to the incoming water temperature and the
environmental temperature.
78° C
73 minutes
14 litres
78° C
66 minutes
11 litres
78° C
40 minutes
8.4 litres
Incoming Water
8 Minutes
2.8 litres
14