Minea WP55G Mode D'emploi page 11

height of which should be no more than 6" above the base of the dishwasher. To allow for
an air gap around the end of the drain hose, the diameter of the standpipe should be at least
30 mm. Connect the other end of the drain hose (L shaped) to the drain port connection at
the back of the dishwasher cabinet. Tighten the drain hose end on to the drain port using the
metal clip included in the package.
If you so wish, you may connect the water inlet hose on to the kitchen sink tap. You must
obtain correct fittings / adaptors to match the inlet hose connectors to ensure secure
connection. However, permanent plumbing is recommended.
If leaks are located, immediately shut the water supply and check the hose connections fully.
Tighten connection if necessary. If for any reason you are unable to stop the leak yourself
please seek advice from a qualified plumber.
The minimum height clearance required to install your dishwasher on a countertop surface
with overhead is 19". Make sure there is an electrical power supply within easy reach of the
machine. The power cord is 6 feet long.
The dishwasher must be installed on a "solid" level surface. To level the dishwasher, adjust
the 4 level screws (feet) under the dishwasher.
3. Water pressure
For best results, incoming water pressure should be between 0.03~1Mpa. Incoming water
supply for the dishwasher is controlled by a "low water switch" application, so if household
water closedown, dishwasher will stop.
Your dishwasher cleans by spraying a mixture of hot clean water and detergent (under
pressure) against the soiled surface of dishes. The water is pumped through a rotating spray
arm, drained through a filter removing food and soiled particles and pumped back through
the spray arm.
Soiled water is pumped out and replaced with clean water at the end of each cycle (the
number of times depends on the cycle being used). For best cleaning results, the water
temperature must be at least 130° F (55° C). To preve nt damage, the temperature of the
incoming water supply should not exceed 160° F (71° C ).
Note : Hard water conditions will adversely affect wash ability performance of your
dishwasher. Hard water conditions will also contribute to "lime" (while film substance)
deposits and / or "scaling" on the stainless steel surface of the dishwasher tub and "heating
element" located in the sump underneath the removable filter screen. To assist in minimizing
these conditions, it is recommended to periodically operate / rinse the inside if the
dishwasher (empty) using 1 cup of white vinegar (at least once a week).
11