Publicité
Les langues disponibles
Les langues disponibles
1. Unit part identification
a) Front view
b) Back view
1 : Inlet
2 : Power line
3 : Drain
c) Programs board
1 : Delay start selector
2 : Programs led
3 : Programs selector
4 : Start / pause button
5 : Power led
6 : Power button
2. Installation instructions
Remove all packing material carefully.
The water inlet hose from the machine terminates in a ¾" female connector. The water
supply should therefore terminate in a similar male connector and should have a stopcock
close by in the pipe. It is recommended to connect the machine to hot water supply. Connect
the straight connector of the inlet hose to the water supply securely. Connect the other end
(bent connector) to the water inlet valve at the back of the dishwasher cabinet. Do not over-
tighten to avoid damage to threads.
Prepare the drainage hose so that it has hooked end. Use the plastic U-bend fitting provided
for this purpose. The end of this should be dropped into a drainage standpipe, the maximum
10
Publicité
