Fellowes POWERSHRED DS-13C Instructions page 3

OPERATION
Continuous operation:
4-5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
4-5 minutes will trigger
20-minute cool down period.
TROUBLESHOOTING
Paper jam: Set to Off and empty basket. Replace basket and follow any or all of the below procedures.
1
2
Press and hold
Alternate slowly back and forth
Reverse (R)
ATTENTION: If the SafeSense ® light remains on, you must engage the
SafeSense ® feature. (See SafeSense ®
SafeSense paper jam: If the SafeSense
®
to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense
feature and clear the paper. Warning – when switch is in override position, the SafeSense
the SafeSense ® feature will NOT function. Once the paper is cleared, reset the SafeSense
MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of defects in
material and workmanship and provides service and support for 1 year from the date of purchase by the
original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material
and workmanship for 3 years from the date of purchase by the original consumer. If any part is found to
be defective during the warranty period, your sole and exclusive remedy will be repair or replacement,
at Fellowes' option and expense, of the defective part. This warranty does not apply in cases of abuse,
mishandling, failure to comply with product usage standards, shredder operation using an improper power
supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge the
PAPER
1 1
1 2
Set to Off
Press Auto-On ( )
CARD
1 1
1 2
Set to Off Press Auto-On ( )
3 4
Set to Off
instructions below.)
®
feature activates (SafeSense
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
1 3
Feed into paper entry
and release
1 3
Hold credit card
at edge
6
5
Pull uncut paper
Press and hold
from paper entry
Reverse (R)
Override Switch in order to perform steps above. Once the jam is cleared, reset the
®
light remains on) to cause the user
® light will flash and
® feature.
2
1 3
*Apply oil Press and hold Reverse
across entry (R) 2-3 seconds
consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country
where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO
THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any
consequential or incidental damages attributable to this product. This warranty gives you specific legal
rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different
limitations, restrictions, or conditions may be required by local law. For more details or to obtain service
under this warranty, please contact us or your dealer.
4
Set to Off
1 5
4
Feed into card Set to Off
entry and release
Shredder doesn't start:
Yellow - SafeSense active
®
Yellow flashing - SafeSense
Make sure control switch is in Auto-On
( ) position
Clear paper particles covering magnetic
safety interlock
Wait 20 minutes for red light to turn off
Sensor light illuminated–paper jammed
®
®
SafeSense override switch
Active
15
not active
®
Not active
3