Fellowes POWERSHRED DS-13C Instructions page 2

A.
B.
C.
D.
E.
Breakthrough Safety Technology! SafeSense
SET UP
— To Test SafeSense
Shredder comes fully assembled. Remove basket packing material and plug in. Disconnect Power Switch must be in ON (I) position to operate shredder.
Press Auto-On ( )
CAPABILITIES
Will shred: Paper, small paper clips, credit cards and staples
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper,
cardboard, large paper clips, laminates or plastic other than noted above
Paper shred size:
Cross-Cut ............................................................................................. 3.9 x 35mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Keep hands away from paper
entry. Always set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away
from shredder openings. If object enters top opening, switch to
Reverse (R) to back out object.
15
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
15
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
• Operation, maintenance, and service requirements are covered in
15
the instruction manual. Read the entire instruction manual before
operating shredders.
2
F.
G.
KEY
H.
I.
A. SafeSense
(yellow)
B. Paper entry
C. Mesh basket
D. SafeSense
switch
stops shredding when hands are too close to the opening.
®
®
Technology
Touch Test Area
Technology E. Step
®
F. Disconnect power switch
G. See safety instructions
below
H. LED Lights
override
®
Overheated (red)
Standby (green)
Active Not Active
Maximum:
Sheets per pass (Cross-Cut) ................................................................................13*
Cards per pass ...................................................................................................... 1
Paper width .................................................................................................230mm
*70g, A4 paper at 220-240v, 2.0Amps; heavier paper, humidity or other
than rated voltage may reduce capacity.
This shredder has a Disconnect Power Switch (F) that must be in the ON
•
(I) position to operate shredder. In case of an emergency move switch to
OFF (O) position. This action will stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Do not put foreign objects in paper entry.
• Shredder must be plugged into a wall outlet or socket of the voltage and
amperage designated on the label. The outlet or socket must be installed
near the equipment and easily accessible. Energy converters, transformers, or
extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
ENGLISH
Model DS-13C
I. Control switch
1. Auto-On
2. OFF
R 3. Reverse
Magnetic
safety interlock
Lift and
remove basket
Sensor lights up