General Pipe Cleaners Power-Vee Mode D'emploi page 6

®
Power-Vee
5. Press replacement cartridge firmly into back of container.
Make sure to line up the grooves in the cartridge with the slots
in the container back.
Slide the cable through the container front.
6.
7. Position the container front so that the three screws aligned
with the slots in the container back. Press the container front
into the container back.
8. Tighten screws firmly, making sure the screw heads are cen-
tered in the slots and flush with the container surface.
Close the Feed Lever Assembly and snap it into place.
9.
MAINTENANCE
DISCONNECT MACHINE FROM POWER SOURCE
BEFORE PERFORMING MAINTENANCE !
To keep your machine operating smoothly, it is essential that all bear-
ings and bushings be lubricated. Oiling moving parts is particularly
important where machine comes in contact with sand, grit and other
abrasive material.
CABLE MAINTENENCE
To get maximum service from your cables,
be sure that they are clean and well oiled.
This not only provides running lubrication
but greatly extends the life of the cables as
well. Some users periodically pour oil
directly into the drum. Then, as the drum
turns, the cables get complete lubrication.
Our SNAKE OIL is ideally suited for this
purpose, since it not only lubricates the
cables, it deodorizes them as well.
FEED MAINTENANCE
Keep feed free of excessive soil and grit. It is recommended that the
feed be flushed with fresh water followed by a light oiling of the mov-
ing parts. No disassembly is normally required. Failure to feed can
usually be traced to dirt accumulation.
Over time, dirt can harden enough to stop roller rotation. Flushing with
water followed by liberal oiling can usually restore function. If disas-
sembly is required, proceed as follows,
TO CLEAN OR REPLACE FEED ROLLERS
1. To clean the Feed Rollers, simply swing open the Feed Lever
Assembly and flush the rollers with WD-40. No disassembly is
required.
2. To replace the Feed Rollers, first remove the Feed Assembly by
loosening the three screws using a 5/32 Allen wrench.
3. Swing the Feed Lever and top roller assembly open.
Top Feed Roller
Feed Lever
4. Remove the Latch in front of the top roller using a #2 Phillips
screwdriver.
5. To remove the top roller, unscrew the Feed Roller Retaining
Screw using a #3 Philips screwdriver. Be careful not to lose the
felt washer.
6. Remove the two lower Feed Rollers by unscrewing the Feed
Roller Retaining Screws using a #3 Philips screwdriver as well.
The lower Feed Rollers do not have felt washer.
7. It is recommended that all three Feed Rollers be replaced at the
same time.
8. After all three Feed Rollers and the Latch are installed, place the
Feed Housing over the Container Front Assembly, line up the
holes, and thread the three 5/32 Allen screws back into place.
Tighten evenly.
9. Close the Feed Lever Assembly and snap it into place.
TO REMOVE MOTOR
1. Loosen the three screws that hold the container front and back
together.
2. Pull the container front off of the machine.
3. Loosen the two set screws in the beveled collar and remove both
the collar and the felt washer.
4. Slide a flat head screw driver into the Hub Spindle and unscrew
the Left Hand locking screw from the drive shaft by turning it
clockwise.
5. Unscrew the Hub Spindle from the Right Hand Drive Shaft by
rotating the container back counter-clockwise. Note: The Hub
Spindle, Hub, and Container Back remain as one unit. The thrust
bearing will spin freely.
6. Reverse these instructions to re-assemble.
6
Lower Feed
Rollers