Paramount JR42 Manuel De L'utilisateur page 9

Option 1: Recessing the Appliance Flush into the Wall
builder before you install this appliance in the wall.
Select a location that is not prone to moisture and is located at least 36" (914mm) away from combustible
materials such as curtain drapes, furniture, bedding, paper etc.
1. Measure the appliance and create a rough in
with electrical.
2. Remove the front glass (refer to Page 14 for
instructions).
3. Remove the LED back lights (refer to Page 15
for instructions).
4.
framing.
5. To fully recess the appliance into the wall:
A. Position and screw the side Builder's
brackets (shown in grey on Page 10) to the set
of holes closest to the front glass as in Figure 2
on Page 8.
B. Use 8-24 screws (provided) to lock appliance
into wall from the side facing out.
C. Install the media and reinstall the glass front.
6. To partially recess the appliance into the
wall (Option 3):
A. Position and screw the side Builder's
brackets (shown in grey on Page 10) to the
second set of holes from the front glass as in
Figure 4 on Page 8.
B. Use 8-24 screws (provided) to lock appliance
into wall from the side facing out.
C. Install the media and reinstall the glass front.
NOTE: Two sets of holes are provided for
recessing into the wall. The wall structure
may limit how far the appliance can be
recessed. Use the appropriate set of holes
when recessing to the frame, it may be
necessary to use the four holes on the top
and bottom.
03.16.21
C1 or C2
FRONT VIEW
B
Page 9