Main Power Switch - Paramount JR42 Manuel De L'utilisateur

Masquer les pouces Voir aussi pour JR42:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating Instructions
WHILE THE APPLIANCE IS OPERATING DO NOT REMOVE THE GLASS PANEL. THIS WILL CAUSE THE
Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
NOTE: Ensure the house circuit breakers for the power supply are turned on. In the event of a power
failure, the appliance will lose its memory function and will reset to factory mode when the power
returns.

Main Power Switch

To turn unit power on:
1. Plug in power cord.
2. Turn on the power switch (located on the front bottom right side of the appliance).
3. Verify the power is turned on when two ring tones are initiated.
Operating with Touch Panel
The unit can be controlled by either the touch panel controls which are located on the right side of the front
glass or the remote control.
1.
1.
Fireplaces ON and OFF
Initial setting
: Heater is
on with red/blue/yellow flame on. Backlight is on with red/yellow/ blue combination (
is white(
).
C3
2.
Flame Brightness adjustment
and OFF for all the flame color options(Red, Yellow, Blue), display
Timer function
3.
8h, 00(timer off) respectively.
4.
Heater temperature setting
in degrees Celsius16-19-21-23-25-27-30-OFF (indicate H0) as a repeat circulation.
Press
key for 5 seconds, then a single "beep" sound will be heard which indicates the temperature switches
to Fahrenheit degree. The parameter is set to Fahrenheit degree of 61-66-70-73-77-80-86-OFF (indicate
as a repeat circulation.
Page 16
REMOTE CONTROL AND TOUCH PANEL TO DISFUNCTION.
Indicator
: Press
power on/off button. Fireplace is turned on. LED displays "
.Flame at the brightest level (
OFF
: Press
: Press "
" multiple times to set the operating duration to 30 min, 1h, 2h, 3h, 4h, 5h, 6h, 7h,
: Press "
WARNING
Heater
Timer
)with red/blue/yellow flame on. Backlight is
F4
button multiple times to cycle through 4 different brightness levels
" key: set the required room temperature. The parameters is pre-set
ON/OFF
Flame
Power
). Ember bed color
C3
F4-F3, F2, F1,FO.
".
ON
)
HO
03.16.21

Publicité

Table des Matières
loading

Table des Matières