Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A QUALIFIED
SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
S
y
m
p
o t
m
Ember bed is not glowing or
dimming
No warm air coming out of
appliance
Appliance turns off and will
not turn on
Appliance will not switch on
when the Power button is
turned ON
Remote control does not work Low battery
Heater shuts off automatically Room is too warm
Touch panel/ Remote Control
do not work
03.16.21
WARNING
P
o r
b
e l
m
LED's are burnt out or
malfunctioning
Room temperature is higher
than the appliance setting (if it
is set to room temperature)
Heater is burnt out
Appliance has overheated
and safety thermal switch has
tripped
House circuit breaker has
tripped
Appliance is not plugged into
an electrical outlet
Appliance has overheated
and safety thermal switch has
tripped
Circuit board is burnt out
The front glass has moved or
is not secured properly
T
e
t s
S
l o
t u
o i
n
Inspect the LED's and replace them if necessary
Reset temperature setting
Inspect the burner and heater assembly and
replace it if necessary
Unplug power cord and allow appliance to cool
for 15 minutes, then plug in the power cord and
turn the power ON
Reset house circuit breaker
Check plug and plug it into a 120V outlet
Unplug power cord and allow appliance to cool
for 15 minutes, then plug in the power cord and
turn the power ON
Inspect the circuit board and replace it if
necessary
Replace battteries in remote control
The heater has a built-in thermostat so it
will shut off automatically once the pre-set
temperature is reached. It will also turn on
automatically if the room temperature drops
below the pre-set temperature.
Unplug the appliance, if the appliance is
recessed into the wall, shut off house circuit
breaker. Ensure the front glass is in the correct
panel. After 10 seconds, plug in or turn on the
appliance to reset it.
Page 25
Publicité
Table des Matières
