mastro 40M Mode D'emploi page 12

5.4 - USE OF THE DISPENSER (see FIG. n°8)
Functioning modalities of the Dispenser:
1. insert the plug in the socket;
2. make sure that the front shelf is well fixed (for models 40M, 45C, 51M);
3. place the film roll in the centre of the rollers (see FIG.n°10);
4. place yourself correctly in front of the machine to avoid accidents (see
FIG.n°11): the body must be perpendicular to the working table; the hands
must not be forced on the machine. WARNING: avoid any contact with the
machine.
5. turn on the Dispenser with the corresponding switch (see FIG. n°9);
6. regulate the thermostat of the plaque at the desired temperature (if provided);
7. lean the tray on the stainless steel table and unroll the film needed for
packing;
8. then cover completely the tray with film;
9. place the tray over the plate (if provided), holding the lateral ends of the film
with the second, third and little finger;
10. lower the tray on the plate (if provided) so that the film is cut by the hot wire
or teflon heated profile;
11. lean the tray on the front shelf (if provided);
12. when the film is correctly tighten, fold the edges underneath;
13. at this stage press the tray on the heating plate, obtaining the sealing.
Afterwards turn the thermostat to 0°C (if provided) and turn off the Dispenser.
N.B.: avoid the machine being out of use for long periods.
FIG. n°11 - Correct position to use the machine
14
5.3 - LOADING OF THE FILM
5.4 - USE OF THE DISPENSER
CHAP. 6 - GENERAL CLEANING
6.1 - INTRODUCTION
CHAP. 7 - MAINTENANCE
7.1 - INTRODUCTION
7.2 - FEET
7.3 - POWER SUPPLY CORD
CHAP. 8 - DISPOSAL OF THE MACHINE
8.1 - PUTTING THE MACHINE OUT OF SERVICE
8.2 - DISPOSAL OF THE MACHINE
CONTENTS
FIG. n°1 - General view of the machine
FIG. n°2 - Overall dimensions drawings
FIG. n°3 - Package description
FIG. n°4 - Rating plate - serial number
FIG. n°5 - Electric circuit diagram of the DISPENSER 40M
FIG. n°6 - Electric circuit diagram of the DISPENSER 45K
FIG. n°7 - Electric circuit diagram of the DISPENSER 45C
FIG. n°8 - Electric circuit diagram of the DISPENSER 51M
FIG. n°9 - Position of controls
FIG. n°10 - Vitafilm loading
FIG. n°11 - Correct position to use the machine
FIG. n°12 - Use of the Dispenser
pag. 15
pag. 16
pag. 16
pag. 6
pag. 7
pag. 8
pag. 9
pag. 10
pag. 10
pag. 11
pag. 11
pag. 12
pag. 13
pag. 14
pag. 15
3