Quick Start - CASO DESIGN Selection C 12 Mode D'emploi

Deactivating aroma mode: Press and hold the button
off.
► It is not possible to change the aroma setting if the brewing process has already started.
► If you pull the mains plug, your settings (including the activation of the aroma strength)
will be deleted.
13.2.2

Quick start

1. Complete the "Preparations".
2. Start the brewing process: press the button
starts the brewing process with the previously set aroma strength.
3. Keep warm mode: When the brewing process is finished, "KEEP WARM is displayed.
The warming plate is heated for another 35 minutes to keep the coffee warm and then
switches off automatically.
► The device shows "KEEP WARM" and the minutes that the device is in the keep warm
mode. The time can be displayed by pressing the button
► The red LED and KEEP WARM light up during the holding process. To end the keep
warm process, press the button
► You can stop the brewing process at any time with the button
switches off.
► The amount of brewed coffee may differ from the amount of water as coffee ground
absorbs different amount of water depending on the amount and degree of grinding of
the coffee ground
► The device is equipped with a drip stop system which enables you to serve coffee
before all the water has dripped through. Quickly put the coffee pot back in place to
avoid any overflowing.
► Do not fill hot water into the watertank.
► Never fill the water tank beyond top mark.
► Wait a few minutes before brewing coffee again. Let the device cool down.
► The warming plate is hot during keep warm. Danger of burns.
► Switch the device off when you have removed the last coffee from the coffee pot. Do not
place empty coffee pot on the hot warming plate.
Please note
Warning
until the display
, the red LED lights up and the device
. The red LED and KEEP WARM switch off.
switches
.
. Then the red LED
34