Resetting To Factory Settings - Steelcase Solo Sit-to-Stand Desk Mode D'emploi Succinct

5. Settings
5.1 Configuring memory positions
Press the "Up" or "Down" button until the desired height is reached.

The display indicates the desk height (e.g. 73 cm).
=
 Press the "SAVE" button.
Press the desired "Memory position" button (e.g. button "2").

The display indicates S 2.
=
The display indicates the desk height after roughly 2 seconds.
5.2 Calling up memory positions
Press and hold the corresponding memory position button (e.g. button "1" or button "2", etc.).

The desktop is moved until the stored desktop height is reached. The desktop movement is stopped
=
whenever the button is released before the memory position has been reached.
5.3 Control panel – lock/unlock
Swipe to the right of the display to "lock or unlock" the control panel.

The control panel is locked or unlocked.
=
Fig. 5-1: Control panel – lock/unlock

5.4 Resetting to factory settings

This function can be used to reset the system to the factory settings.
 Press and hold the buttons shown below for 3 sec.:
1 Press buttons "1" and "2" and the
2 "Up" button
The letter S and a number (e.g. S 4) are shown on the display.
=
Press the "Down" button until S 0 is shown on the display.

The display indicates S 0
=
Press the "SAVE" button.

The system has now been reset to the factory settings.
=
158069
Solo Sit-to-Stand Desk
EN
Rev. A