Correct Disposal Of This Product; Before You Begin - Waring Commercial WSB Série Mode D'emploi

TYPE F PLUG
(GERMANY, AUSTRIA, NETHERLANDS,
SWEDEN, NORWAY, FINLAND,
PORTUGAL, SPAIN, EASTERN EUROPE)
TYPE G PLUG
(UNITED KINGDOM, IRELAND,
CYPRUS, MALTA, MALAYSIA,
SINGAPORE AND HONG KONG)
TYPE I PLUG
(ARGENTINA, AUSTRALIA, CHINA,
NEW ZEALAND, PAPUA NEW GUINEA)

Correct Disposal of this product

BEFORE YOU BEGIN

NOTE: Always unplug the Waring
cleaning the metal blade.
Before using the Immersion Blender, Waring suggests that you wipe
the unit with a clean, damp cloth to remove any dirt or dust. While
detached, place metal blade at the end of the shaft under running
water to rinse it. Dry thoroughly with a soft, absorbent cloth. Read all
instructions carefully for detailed operating procedures.
This grounded plug has two round prongs and there are two
grounding clips on the side of the socket. This plug is non-
polarized so the plug can be inserted in either direction into
the socket. Grounding is accomplished when the clip on the
socket meets the contact on the plug. Ensure that the plug
is fully inserted.
This grounded plug has three rectangular prongs that form
a triangle. Line up the prongs to the socket and ensure that
the plug is fully inserted. This plug is also fuse-protected for
power surges.
This grounded plug has two flat pins in a V-shape as
well as a grounding pin.
This marking indicates that this product should not be
disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They
can take this product for environmentally safe recycling.
Immersion Blender before
®
3