Spot Welding - ims PRO TIG PRO 201 DC FV Mode D'emploi

Operating manual

SPOT welding

This welding mode allows the pre-assembly of parts before welding. Scoring can be manual by trigger or delayed with a predefined scoring delay. This
spot timer allows for a better reproducibility and the realisation of non-oxidized spots (accessible with the «F(Hz)» button).
Description
Pre-gas
Welding current
Spot
Post-gas
SPOT PULSE welding
This welding mode on thin sheet metal allows the pre-assembly of parts before welding. Scoring can be manual by trigger or delayed with a predefined
scoring delay. This spot timer allows for a better reproducibility and the realisation of non-oxidized spots (accessible with the «F(Hz)» button).
Description
Pre-gas
Welding current
Spot pulse
Post-gas
30
Translation of the original
instructions
The grey areas are not useful for this mode.
Setting Recommendations
0 - 60 s Time to purge the torch and to protect the area with gas before ignition
10 - 200 A Welding current
Man, 0,1 - 60 s Manual or a defined time.
Duration for which gas is released after the arc has stopped. It protects the weld pool and the elec-
0 - 60 s
trode against oxidisation when the metal is cooling down.
The grey areas are not useful for this mode.
Setting Recommendations
0 - 60 s Time to purge the torch and to protect the area with gas before ignition
10 - 200 A Welding current
Man, 0,01 - 60 s Manual or a defined time.
Duration for which gas is released after the arc has stopped. It protects the weld pool and the
0 - 60 s
electrode against oxidisation when the metal is cooling down.
TIG SPOT
TIG PULSE SPOT
TIG PRO 201 DC FV