ims PRO TIG PRO 201 DC FV Mode D'emploi page 28

Operating manual
SELECT IGNITION MODE
TIG HF High Frequency start without contact.
TIG Lift contact ignition (for environments sensitive to HF disturbances).
1 2
1 2
Warning: Increasing the length of the torch or earth return cables beyond the maximum length specified by the manufacturer will increase the risk of
electric shock.
TIG DC - STANDARD
• StandardThe TIG DC Standard welding process allows high quality welding on most ferrous materials such as steel, stainless steel, but also
copper and its alloys, titanium. The many possibilities of current and gas management allow you to perfectly control your welding operation, from
priming to final cooling of your welding rod.
28
Translation of the original
instructions
3
1- Place the torch in the welding position above the part (distance of about 2-3 mm
between the electrode tip and the part).
2- Press the torch trigger (the arc starts without contact using High Frequency impul-
sions).
3- The initial welding current circulates, the welding carries on according to the
welding cycle.
3
1- Position the torch nozzle and electrode tip on the part and press the torch button.
2- Tilt the torch until a distance of about 2-3 mm separates the tip of the electrode
from the part. The arc starts.
3- Put the position back into position to start the welding cycle.
TIG DC Standard
The grey areas are not useful for this mode.
TIG PRO 201 DC FV