Ergon CF3 Pro Carbon Instructions D'installation Et D'utilisation page 61

ERGON BIKE ERGONOMICS
Fit the anti-slip shim unprinted side down onto the inner side of the rear leaf
spring (the one marked BACK). The marking on the anti-slip shim should be level
with the noted saddle height 'b' so that the shim is about in the middle of the
binder bolt clamping area when the post is placed back in the bike at the correct
height. (Fig. E). Fit the washer and lock screw and lightly tighten the lock screw
2 turns (Fig. F).
Fig. E: Place the Anti-Slip shim on the inside of
the rear leaf spring as indicated.
b
b
Fig. F: Fit the washer and lock screw and fasten
loosely.
61
EN
2 x