Lukas STRONGARM e100 Manuel D'utilisation page 73

3. Remove lock screw with an Allen key (2 mm / 0.08 in.).
4. Unscrew nut of pivot bolt ( wrench size 30) and remove bolt.
5. Remove retaining rings on both blade arm bolts and remove them.
6. Remove blade arms and replace with new ones.
7. Reassembly is carried out in reverse order.
Lock nut
Blade arm
Pivot bolt
ATTENTION!
Don't forget to apply LUKAS special grease to all sliding surfaces.
NOTE:
The torques specifications required can be taken from the spare parts list of your
particular unit.
10.3.4 Decals
All damaged and/or illegible decals (safety notices, type plate etc.) must be replaced.
Procedure:
1. Remove damaged and/or illegible decals.
2. Clean surfaces with industrial alcohol.
3. Affix new decals.
Take care to affix the labels in the correct positions. If this is no longer known, you should ask
your authorized LUKAS dealer or contact LUKAS directly.
Lock screw
Retaining ring
73
Blade arm bolt