18
CVS Series
Painting
If desired, the grille and baffl e panel may be painted to match the surrounding décor.
Painting the baffl e:
• Carefully mask off the driver assembly using the paint-mask provided to ensure that the paint does not come into contact with the cone and roll surround
• Apply several thin coats of paint – this will provide a better fi nish than one overly thick coat
Painting the grille:
• Carefully remove the acoustically transparent foam from the reverse side of the grille
• Paint the grille and then replace the foam - several thin coats of paint will provide a better fi nish than one overly thick coat
• Re-bond the foam to the grille over the entire area using a light spray-adhesive to avoid audible resonances
Technical Specifi cations
CVS 8
System
Frequency response (-3 dB)1
79 Hz - 21 kHz
Frequency response (-10 dB)1
60 Hz - 24 kHz
System Sensitivity (1 W @ 1 m)2
93 dB (1 W = 2.45 V for 6 Ohms)
91 dB (1 W = 2.45 V for 6 Ohms)
Nominal Coverage Angle
90 degrees conical
Coverage Angle (1 kHz to 6 kHz)
84 degrees conical
Directivity Factor (Q)
14.7 averaged 1 kHz to 6 kHz
Directivity Index (DI)
11.7 averaged 1 kHz to 6 kHz
111 dB (average)
Rated Maximum SPL
117 dB (peak)
Power Handling3
Average
60 W
Programme
120 W
Peak
240 W
Recommended Amplifi er Power
120 W @ 6 Ohms
Nominal Impedance
6 Ohms
Transformer Taps (via front rotary switch)
70 V
60 W / 30 W / 15 W / 7.5 W / OFF &
60 W / 30 W / 15 W / 7.5 W / OFF &
low impedance operation
100 V
60 W / 30 W / 15 W / OFF &
low impedance operation
Transducers
Coaxial 200 mm (8.00") mineral loaded
150 mm (6.00") mineral loaded
Low Frequency
cone material
High Frequency
19 mm (0.75")
Physical
Enclosure
Back can
Zinc plated steel
Baffl e
Refl ex loaded UL 94V-0 rated ABS
Refl ex loaded UL 94V-0 rated ABS
Grille
Steel, with weather resistant coating
Steel, with weather resistant coating
Safety ring located at rear of enclosure
Safety ring located at rear of enclosure
Safety Features
for load bearing safety bond
Clamping Design
Security toggle clamp
Back Can Options
Cable clamp & squeeze connector for
Cable clamp & squeeze connector for
Cable Entry Options
conduit up to 22 mm
Removable locking connector
Removable locking connector
Connectors
with screw terminals with
"loop through" facility
Safety Agency Ratings
UL-1480, UL-2043, CE
Hole Cutout Diameter
320 mm (12.60")
Dimensions Bezel diameter
355.6 mm (14.00")
Front of ceiling to rear of back can
251.0 mm (9.88")
Front of ceiling to top of safety loop
264.0 mm (10.39")
Net Weight (ea)
6.6 kg (14.6 lbs)
C Ring, tile bridge, paint mask,
C Ring, tile bridge, paint mask,
Included Accessories
cutout template, grille
Optional Accessories
Plaster (mud) ring
Notes
(1) Average over stated Bandwidth. Measured in an IEC baffl e in an Anechoic Chamber
(2) Unweighted Pink noise input, measured at 1 m on axis
(3) Long term power handling capacity as defi ned in EIA - 426B test
Quick Start Guide
CVS 6
CVS 4
CVS 4 MICRO
79 Hz - 21 kHz
85 Hz - 19 kHz
110Hz - 19kHz
60 Hz - 24 kHz
77 Hz - 22 kHz
90Hz - 22kHz
87 dB (1 W = 2.45 V for 6 Ohms)
90 degrees conical
93 degrees
102 degrees
7.7 averaged 1 kHz to 6 kHz
5.6 averaged 1 kHz to 6 kHz
8 averaged 1 kHz to 6 kHz
7.1 averaged 1 kHz to 6 kHz
109 dB (average)
103 dB (average)
115 dB (peak)
109 dB (peak)
60 W
40 W
120 W
80 W
240 W
160 W
120 W @ 6 Ohms
80 W @ 6 Ohms
6 Ohms
6 Ohms
30 W / 15 W / 7.5 W / 3.75 W / OFF &
15 W / 7.5 W / 3.75 W / 1.9 W / OFF &
low impedance operation
low impedance operation
low impedance operation
60 W / 30 W / 15 W / OFF &
30 W / 15 W / 7.5 W / OFF &
15 W / 7.5 W / 3.75 W / OFF &
low impedance operation
low impedance operation
low impedance operation
100 mm (4.00") mineral loaded cone material
polypropylene ICT™
19 mm (0.75")
19 mm (0.75")
Zinc plated steel
Zinc plated steel
|
Painted steel
Refl ex loaded UL 94V-0 rated ABS
Steel, with weather resistant coating
Safety ring located at rear of enclosure for load bearing safety bond
for load bearing safety bond
Security toggle clamp
Security toggle clamp
Cable clamp & squeeze connector for conduit up to 22 mm
conduit up to 22 mm
with screw terminals with
Removable locking connector with screw terminals with "loop through" facility
"loop through" facility
UL-1480, UL-2043, CE
UL-1480, UL-2043, CE
250 mm (9.84")
180 mm (7.08")
279.5 mm (11.01")
213.0 mm (8.39")
246.5 mm (9.70")
98.3 mm (3.87")
202.5 mm (7.97")
258.5 mm (10.18")
46.5mm (1.83")
214.9 mm (8.46")
5.7 kg (12.6 lbs)
3.6 kg (7.9 lbs)
2.8 kg (6.2 lbs)
C Ring, tile bridge, paint mask, cutout template, grille
cutout template, grille
Plaster (mud) ring
Plaster (mud) ring
19