Accessories - WOLFF MAMBO Evo D Mode D'emploi

(4)
The speed for finish grinding on levelling compounds
should not be higher than 200 r.p.m. Otherwise the
adherence of adhesives may be severely reduced.
08/2010 Schleifmaschine MAMBO Evo, Artikel-Nr. 061804
Speed control
Adjust the speed of the discs with switch (4). Turning clock-wise
increases the speed, turning anti-clock-wise decreases the
speed. The optimal speed is dependent on the disc used and
the subfloor.
The table below It is meant as guiding principle for the user.
Always test the optimum speed in each case. Always start at
low speed and then increase the speed.
Speed Use
160-200 Grinding screed and
levelling compounds
200-300 grinding parquet
removing levelling compounds
and adhesive residues
300-400 Polishing resilient flooring
Removing the sealing of
resilient floors
removing levelling compounds
Always remove discs or brushes after work.
Always disconnect the power cord after work or when leaving the
machine.
Transportation
For transportation fold the handle forwards. Remove the locking
pins (5) in order to tilt the handle. For carrying the machine, use
(5) the grips at the front and at the back.
6.0 Accessories for the grinding machine
6.1 Vacuum unit
The vacuum unit Micropac or an external industrial vacuum
cleaner may be used.
Mounting the vac Micropac (Item-No. 038501)
Assemble the vacuum unit from the front of the handle of the
machine.
insert vac into the lower support
turn vac at the top against the handle. Engage
fixing pin.
fasten hose to the vac by turning clockwise
attach hose to the outlet spigot of the machine
Recommended disc
Grinding paper, grinding
gauze
Grinding gauze
Carbide grinding disc and
System- milling disc
Pads
Scrubbing brush
System- milling disc
16