Commissioning; Switching On; Setting The Air Flow (Optional) - Simco-Ion BlowION Notice D'utilisation

7. Commissioning

Control
knob
Figure 1
Warning:
- Never insert any object into the air inlet grid. This causes damage to the fans.
- Do not touch the high-voltage points. These are sharp and, during operation, they will
cause an unpleasant electrical shock (max. 0.7 mA).
- If you have a pacemaker, you must not touch the high-voltage components of the
BlowION.

7.1. Switching on

- Ensure that the blower is connected to mains voltage.

7.2. Setting the air flow (optional)

The quantity of air blown out can be set using the control knob on the front of the blower.
- Set the required air quantity by turning the potentiometer anticlockwise or clockwise.
1. Remove the plug at the front panel of the blower.
2. Use a small flat screwdriver to set the required air quantity by turning the potentiometer
behind the front panel either clockwise or anti-clockwise.
3. Press the plug back into the hole to protect the potentiometer.
BlowION_UM_9752060910_NL_D_GB_F_V2_3
GB
21