LaserLiner MultiMeter-Compact Mode D'emploi page 16

– Disconnect the power supply to the electrical circuit before
measuring or checking the diodes, resistance or battery charge.
– Check that all high-voltage capacitors are discharged.
– When connecting to a voltage, always connect the black
measuring lead first before the red lead. Follow the reverse
procedure when disconnecting.
– Only the original measuring leads may be used. Their voltage,
category and ampere rated powers must match those of the
measuring device.
Additional information on use
Observe the technical safety regulations for working on electrical
systems, especially: 1. Safely isolating from power supply, 2. Secu-
ring to prevent system being switched on again, 3. Checking zero
potential, two-pole, 4. Earthing and shortcircuiting, 5. Securing
and covering adjacent live components.
Safety instructions
Dealing with electromagnetic radiation and electromagnetic
disruptions
– The measuring device complies with electromagnetic compatibility
regulations and limit values in accordance with EMC-Directive
2014/30/EU
– The measuring device complies with safety and electromagnetic
compatibility regulations and limit values in accordance with
Directive 2014/35/EU (Low Voltage Directive / LVD) and 2014/30/EU
(Electromagnetic Compatibility Directive / EMC).
– Umarex GmbH & Co. KG hereby declares that the MultiMeter-
Compact complies with the essential requirements and other
provisions of the European Low Voltage Directive 2014/35/EU (LVD)
and the Electromagnetic Compatibility Directive 2014/30/EU.
The EU Declaration of Conformity can be found in its entirety
at the following address: http://laserliner.com/info?an=ADV
– Local operating restrictions – for example, in hospitals, aircraft,
petrol stations or in the vicinity of people with pacemakers –
may apply. Electronic devices can potentially cause hazards
or interference or be subject to hazards or interference.
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning
agents, scouring agents and solvents. Remove the battery(ies)
before storing for longer periods. Store the device in a clean and
dry place.
16
EN