ORTHOSCOOT NH1 Mode D'emploi page 38

If the quick-release lever can be closed too easily or not at all open it once more and readjust the adjusting nut.
The adjusting nut is inside the handlebar stem. In order to have free access to the adjusting nut you have to open
the quick release skewer once more and to fold back the handlebar unit.
Completely push back the red safety knob at the side
and open the quick-release lever.
If it is too easy to close the lever, tighten the adjusting
nut somewhat clockwise.
If it is too difficult or not possible at all to close the
lever, loosen the adjusting nut somewhat by turning it
counterclockwise.
36

Completely fold back the handlebar unit in order to
have free access to the adjusting nut.
Now fold the handlebar unit upwards again and close
the quick-release lever once more. The tension is
correct if the lever can be levered until the end with
slightly in creased pressure.
All other quick-release clamps (without red button)
on the NH1 can be adjusted according to the same
principle using a lock nut.
ORTHOSCOOT NH1
®