Technical Parameters - Ayce DC-057 Manuel D'utilisation

CHECK THE MALFUNCTION AND REPAIR
If your humidifier does not work, contact JUMBO.
MALFUNCTION CAUSE
Didn't connect the power
supply
1. Power indicator can't
work and with no wind
and mist Didn't turn on the
humidifier
2. Power indicator
No water in the water
illuminate, the unit with
tank
wind but no mist
New humidifier
3. Smelly mist
Dirty water or long-time
to store water in water
tank
4. Power indicator
Too much water in the
illuminate, the unit with
base flume
no wind and mist
Dirty ultrasonic
transducer
5. Little mist comes out of
the nozzle Dirty water or long-time
to store water in water
tank
Caused by little water in
water tank.
6. Abnormal noise
Resonance from table-
board
If your humidifier still can't work after dealing with above methods, please contact
Jumbo.
RESOLVE METHODS
Connect the humidifier
from the power supply
Switch on the unit
Fill water in water tank
Open water tank, put it in
shadow for 12 hours.
Clean the water tank, fill
clean water in.
Empty the flume, then
close the cap of water
tank.
Clean the transducer
Clean the water tank, fill
clean water in.
Fill water in water tank.
Place on a stable level
surface.

Technical Parameters

Model
Voltage
Power
Water tank capacitor
Humidifying capacity
Adapted room size
Type of the battery for remote controller
44 | 45
DC-057
220-240 V~ / 50 Hz
30 W
4.0 L
300 ml/h
2
45 m
1 x CR2025 (non fourni)
G