Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Indicator lamp
The green power-ON indicator lamp lights up when the
tool is switched ON. If the indicator lamp is lit but the tool
does not start, the carbon brushes may be worn out, or
the electric circuit or the motor may be defective. If the
indicator lamp does not light up and the tool does not
start, the ON/OFF switch or the mains cord may be
defective.
The red service indicator lamp lights up when the carbon
brushes are nearly worn out to indicate that the tool
needs servicing. After approx. 8 hours of use, the motor
will automatically be shut off.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Side handle (auxiliary handle)
1
2
The side handle can be swung 360° on the vertical and
secured at any desired position. It also secures at eight
different positions back and forth on the horizontal. Just
loosen the clamp nut to swing the side handle to a
desired position. Then tighten the clamp nut securely.
The side handle also can be mounted in the rear groove.
Loosen the clamp nut and widen the side handle base.
Slide the side handle back to the rear groove and secure
it with the clamp nut.
002899
1. Power-ON indi-
cator lamp
(green)
1
2. Service indica-
tor lamp (red)
2
002906
1. Side handle
2. Clamp nut
1
2
Installing or removing the bit
This tool accepts 3/4" Hexagonal and 21/32" round
shank bits.
Clean the bit shank and apply bit grease before installing
the bit.
2
Pull the tool holder cover down all the way. With the cut in
the bit shank aligned with the notch in the tool holder cap,
insert the bit into the tool holder.
1
2
Release the tool holder cover. It will return automatically
to its original position to secure the bit. After installing,
always make sure that the bit is securely held in place by
trying to pull it out.
To remove the bit, pull the tool holder cover down all the
way and pull the bit out.
5
002907
1. Side handle
base
2. Clamp nut
002919
1. Bit grease
2. Bit shank
1
002920
1. Bit
2. Tool holder
5
cover
4
3. Tool holder cap
3
4. Notch
5. Cut in the bit
shank
002921
Publicité
Table des Matières
