Resetting To Default Factory Settings; Need Help - Philips SBC SC477 DECT Instructions Pour L'utilisation

ENGLISH
14
SYSTEM
1 2
LEVEL
1
SYSTEM
2
POWER

Resetting to default factory settings

Factory Initialisation mode
With this mode both units can be reset to the default factory settings.
Factory Initialisation can be used if problems occur which can not be
solved by following the suggestions in chapter 'Problem solving'.
1 Make sure the units are within a range of 1 metre from each
other.
2 Switch off both units.
Note:The units have to be put in Factory Initialisation mode together.
Therefore step 4 should be executed within 5 seconds after the
DECT system check light on the Baby unit starts blinking (step 3).
3 Keep TALK button on Baby Unit pressed for at least 6 seconds,
while turning on the power (power on switch to MONITOR or
INTERCOM).
> The DECT system indicators will blink alternatively red/green.
4 Keep TALK button on Parent Unit pressed for at least
6 seconds, while pressing the POWER button.
> The DECT system indicators will blink alternatively red/green.
> When the units have found each other (normally within
30 - 120 seconds) this will be indicated by a 'beeping' sound from both
units.Then connection will be re-established.
Note: By exectuting the factory initialisation mode Parent Volume, Baby Volume
and Baby Sensitivity are automatically reset to their factory default
settings. Personal preferences need to be set again.
Factory default settings are:
- Parent Volume: 3 lights
- Baby Volume: 3 lights
- Baby Sensitivity: 3 lights

Need Help?

In case you have any questions about the SC477, please contact our
helpline for assistance! You can find the number in the list on page 2.
Before you call, please read this manual carefully.
You will be able to solve most of your problems.
The model number of the baby monitor is SBC SC477.
Date of purchase: _____ /_____ /______
day /month /year