vollara SAFE HEARTH Mode D'emploi page 9

Remote Control Care
When remote control will not be in use for
a long period of time, remove the battery
according to the following steps.
Push battery cover lock up then pull cover out as
indicated in the diagram above. When replacing
the battery, positive side faces up.
ACTIVEPURE CELL CLEANING AND REPLACEMENT
WARNING:
• Turn off the power switch in the rear of the unit.
• Unplug the unit and let it cool completely.
1. Remove the screws from the filter bracket on
the back of the unit. Remove the bracket and filter.
2. Using the tabs, lift out the ActivePure cell.
3. Disconnect the two pin connectors and remove the entire
ActivePure assembly from the unit.
4. The ActivePure cell and filter can now be replaced or cleaned. To
clean, carefully vacuum or brush the ActivePure cell and filter.
The ActivePure cell should be cleaned whenever you clean the
filter, every 3-6 months or as needed.
5. If damaged, worn, or difficult to clean, replace the filter and/or
ActivePure cell. ActivePure cell should be replaced every 2 years,
or as needed.
NOTE: For a replacement ActivePure Cell, or for replacement
filters, contact your independent Vollara Distributor for
more information.
Filter: Part # 49857
6. Reassemble the ActivePure cell, by connecting the two pin
connectors and sliding into place. Reassemble the filter, back
cover, and holder assembly as shown.
7. Reconnect power
WARNING! - The filter and ActivePure Cell must
be properly installed. DO NOT OPERATE THIS
APPLIANCE WITH THE FILTER REMOVED. Failure to
follow these instructions may result in exposure to
UV light or personal injury.
ActivePure Cell: Part# 49856
Battery cover
ActivePure cell
ActivePure cell tab
Battery
Filter
Filter bracket
Screws
9