Control Panel - vollara SAFE HEARTH Mode D'emploi

CONTROL PANEL

5
1. Mode Settings – Control the power output.
Eco - 500 watts
Low - 1000 watts
High - 1500 watts
2. ActivePure Mode – Press the ActivePure button to turn
the ActivePure cell on or off. The cell is active when the
ActivePure LED is illuminated.
3. Power Button – Press for Power On or Off.
4. LED Display – indicates set temperature or hours
TO RUN AS AIR PURIFIER ONLY
1. Power Unit ON using switch on back of unit .(Do not press power button (
2. Press ActivePure ( ) button on Control panel. Fan and AP Cell will run providing air purification without heating.
3. Press ActivePure button again to turn off.
6 1
5. Timer Button – Press the Timer Button when the
heater is on to set the hours until the unit turns off. Or
press the Timer Button when the heater is off to set a
time for the unit to turn on automatically. Time can be
set for up to 12 hours.
6. Temperature Control – Use the up button to set a
warmer temperature and the down button to lower the
heat.
7. Temperature Display – As you set the temperature
higher or lower, the temperature display will indicate
the desired warmth.
2 3
) on control panel)
4
7
5