Remote Panel; Preparation - vollara SAFE HEARTH Mode D'emploi

REMOTE PANEL

PREPARATION

Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Turn on the power switch
in the rear of the unit. Only operate heater in an upright position with caster wheels attached.
When using remote control, please pull out the insulating film as illustrated below.
6
Power button – Power on or off
Mode Settings – Control the power output
• ECO - 500 watts
• Low - 1000 watts
• High - 1500 watts
Timer Button – Press the Timer Button when the heater is on to set
the hours until the unit turns off. Or press the Timer Button when
the heater is off to set a time for the unit to turn on automatically.
Temperature Control – Use the up button to set a warmer
temperature and the down button to lower the heat.
ActivePure Button – Turns ActivePure on or off.