Setting The Timer; Filter Cleaning - vollara SAFE HEARTH Mode D'emploi

SETTING THE TIMER

MAINTENANCE
WARNING:
• Turn off the power switch in the rear of the unit.
• Unplug the unit and let it cool completely.
Unit Cleaning
• To keep the heater clean, the outer shell may be cleaned with a soft cloth.
CAUTION: DO NOT let liquid enter the heater.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause
damage or deterioration to the surface of the heater.
• DO NOT immerse the heater in water.
• Wait until the unit is completely dry before use

Filter Cleaning

NOTE: Always disconnect from power before removing filter for cleaning.
Filter requires cleaning after every 3-6 months of use, or as needed. Please remove the filter following the steps below.
Once removed, flush and clean the filter with water, then allow to air-dry completely before reassembling.
The unit
8
Press Timer button either on the control panel or remote control.
To set the Heater to automatically turn off, press the Timer button with the unit ON. To set the
Heater to automatically turn on, press the Timer button with the unit OFF. Press continuously
until the LED on the control panel displays the desired length of time. Time can be set in 1–12 hour
increments. The Timer will begin immediately.
DO NOT put liquids inside the heater.
Filter
Filter bracket
Screws