Unpacking - Master MH-375T-GFA-A Manuel D'instructions

RISK OF ELECTRIC SHOCK!
WARNING
Electrical Grounding In-
WARNING
structions: This appliance is
equipped with a three-prong (grounding) plug
for your protection against shock hazard and
should be plugged directly into a properly
grounded three-prong receptacle.
For use with propane (LP)
WARNING
gas only.
ALWAYS install the heater so that it is not directly ex-
posed to water spray, rain, dripping water, or wind.
Use heater in accordance with all local codes. In the
–
absence of local codes, refer to The National Fuel
Code, ANSI Z223.1.
This heater is shipped from the factory for use with
–
propane (LP) gas only. Do not convert to any other
gas. Installation must conform to local codes, or in
their absence, with the standard for the Storage and
Handling of Liquefied Petroleum Gases ANSI/NFPA
58 and the Natural Gas and Propane Installation
Code CSA B149.1.
Gas supply connections should be checked by using
–
a 50/50 soap and water solution. Never use a flame
to check for gas leaks.
Locate LP cylinder at least 6 feet (10 ft. in Canada)
–
from the heater, and do not direct heater discharge
towards the LP cylinder unless it is at least 20 feet
from the heater.
RISK OF FIRE! DO NOT POSITION HEATER IN A DOWNWARD ANGLE. ALWAYS
WARNING
LOCATE HEATER ON A STABLE AND LEVEL SURFACE (SEE FIGURE 1)!
Figure 1
1. Remove all packing items applied to heater for
shipment. Keep plastic cover caps attached to
inlet connector and hose / regulator assembly
for storage.
2. Remove all items from carton
© 2019 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE
CONNECTED TO A FUEL SOURCE
SAFETY INFORMATION (CONT.)

UNPACKING

Use only the regulator and hose assembly provided
–
with this heater. Inspect the regulator/hose assembly
prior to each use of the heater. If there is excessive
abrasion or wear, or if the hose is cut, replace it with
the proper assembly shown in the parts list, prior to
using the heater.
The hose assembly shall be visually inspected prior
–
to each use of the heater. If it is evident there is
excessive abrasion or wear, or the hose is cut, it
shall be replaced prior to the heater being put into
operation. The replacement hose assembly shall be
that specified by the manufacturer.
Manifold, Minimum, and Maximum Supply Pressure
Man.
Min.
Max.
WARNING
building material and contact with hot surfaces
both during use and while in storage.
X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X
3. Check all items for shipping damage. If the
heater is damaged, promptly inform dealer
where you purchased the heater.
The Propane (LP) gas pressure
CAUTION
regulator and hose assembly
supplied with the heater must be used without
alteration.
5 Propane Forced Air Heater User's Manual
MH-375T-GFA-A
7–10 PSI
23 PSI
Bottle Pressure
The hose assembly
shall be pro tected
from traffic,