dirna Bergstrom Bycool Blue Série Instructions De Montage page 30

FLAT
EN ES
Fit the internal air distribution panel on the
9
front studs with M6 wide-flange washer (1)
and M6 nut (1) on each stud. Tighten nuts until
the ducts stop at the top foam rubber on the
device. Important: the ducts should stop
against the foam rubber to prevent air leaks.
9
EPDM
Gasket
Cabin roof
Upholstey
Tighten nut mentioned under point 9 until it
10
touches upper surface of front.
10
EPDM
Gasket
Cabin roof
Upholstey
Place console and centre equipment in the most
11
convenient place of cabin roof. Once centred,
remove console for later installation.
Unit base
Nut M6
Stud M6
Unit base
Nut M6 (9a)
Nut M6
Stud M6
Air ducts
Air ducts
30
Air conditioning for vehicles
Foam rubber
Interior air
distribution panel
Foam rubber
Interior air
distribution panel
9